Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Clopay Torsion Spring Replacement: The Van Nuys Owner’s Guide
We stock and install Clopay-compatible torsion spring replacements for most residential models in Van Nuys, with typical installed pricing from $180 to $340 and same-day availability when you call before early afternoon. Most homeowners discover the problem on a Tuesday morning when the door groans halfway up and stops, or when they spot a two-inch gap in the coiled spring above the header. The door should open. Let’s make sure it does.
Which Clopay Models This Applies To
Clopay has built garage doors under several series names over the decades, and the torsion spring must match the door’s weight, track configuration, and drum type. We regularly replace springs on Classic, Gallery, and Coachman series doors in Van Nuys, along with older Premium and Value Plus units still running from the 1990s and 2000s.
The critical identifier is the winding cone color and wire size stamped on the existing spring. Clopay OEM springs typically use orange or black winding cones depending on the series year, with wire diameters ranging from .207 to .283 inches for residential doors. The left-hand and right-hand springs are not interchangeable, and the length must be measured while relaxed, not under tension.
We carry quality aftermarket equivalents that match Clopay’s torque specifications without the OEM markup. For most Van Nuys homeowners, the aftermarket spring lasts the same lifespan and carries our 90-Day Done Right Promise. We are an independent service provider, not affiliated with Clopay, so we recommend what fits your door and budget.
Signs Your Clopay Torsion Spring Replacement Is Failing
- The door lifts a few inches and stops. One spring has broken, and the remaining spring cannot lift the full door weight. The opener strains against the load, which burns out the motor if you keep pressing the button.
- You hear a loud bang from the garage, then the door feels heavy. That bang is the spring releasing its stored energy. In Van Nuys, we see this most often in spring when temperature swings stress metal that has already cycled through fifteen years of daily use.
- The door opens crooked or one side hangs lower. A weakening spring on one side loses torque faster than its partner. The cables slip on the drum, and the door tilts in the tracks.
- The manual lift test feels suddenly heavy. Disconnect the opener and try lifting by hand. A balanced door should stay at mid-height. If it crashes down, at least one spring has lost its wind.
- You spot a visible gap in the coil. A broken torsion spring often separates by one or more coils. Look above the door at the spring mounted on the shaft. A gap means replacement, not repair.
Replacement Cost & What’s Included
| Service | Price Range in Van Nuys |
|---|---|
| Single torsion spring replacement (standard Clopay door) | $180 - $260 |
| Dual spring replacement (heavier Clopay models) | $260 - $340 |
| Cable replacement (if frayed during failure) | $130 - $250 |
| End bearing or center bearing plate | $120 - $200 |
What drives the range: door weight, spring wire size, and whether the failure damaged cables or bearings. We state the flat price before any work begins. The quote includes the spring, labor, safety inspection of cables and rollers, and lubrication of all moving parts. Every job carries our 90-Day Done Right Promise in writing. If it is not right, we come back at no charge.
DIY or Call Us?
There is one safe check a homeowner can make: look for the gap in the spring or test the door balance with the opener disconnected. Beyond that, torsion spring replacement is not a DIY project. These springs hold enough torque to cause serious injury or worse if the winding bars slip.
We have seen bent winding bars, broken wrists, and doors pulled off their tracks from attempted self-repairs in the Valley. Our technicians carry the correct winding bars, vice grips, and ladder setup. Most Clopay torsion spring replacements in Van Nuys take under ninety minutes, and we finish in one visit because the springs are already on the truck. Call (747) 836-1998 for a free estimate.
FAQs
Most rated for 10,000 cycles, which translates to seven to twelve years for a typical household. In Van Nuys, the dry heat and occasional Santa Ana temperature spikes accelerate metal fatigue slightly compared to coastal climates. Call (747) 836-1998 for an exact quote, estimates are free.
No. Once a torsion spring breaks or loses its wind, replacement is the only safe option. We do not attempt to reweld, splice, or patch springs. The flat price for a new spring is stated before work begins. Call (747) 836-1998 for an exact quote, estimates are free.
Most Clopay torsion spring replacements take sixty to ninety minutes from arrival to testing. We arrive with the springs on the truck, so there is no waiting for parts. Call (747) 836-1998 for an exact quote, estimates are free.
Yes. We carry the common wire sizes and lengths for Clopay’s residential series, including the .218 and .250 wire sizes we see most often in Van Nuys. For older or unusual configurations, we source overnight and return the next day. Call (747) 836-1998 for an exact quote, estimates are free.
Written by Carl Dutton, Owner, Mainspring Garage Door Co. at Mainspring Garage Door Co., serving Van Nuys and nearby areas.






Before
After
Before
After
Before
After